wiki:development:build-howto-linux:pyhoca-cli
Differences
This shows you the differences between two versions of the page.
| Next revision | Previous revision | ||
|
wiki:development:build-howto-linux:pyhoca-cli [2011/11/15 10:21] sunweaver created |
wiki:development:build-howto-linux:pyhoca-cli [2013/03/08 13:31] (current) |
||
|---|---|---|---|
| Line 1: | Line 1: | ||
| - | ====== Build PyHoca-GUI for GNU/Linux ====== | + | ====== Build PyHoca-CLI for GNU/Linux ====== |
| + | |||
| + | //... esp. applies to installation on the Linux-From-Scratch distribution.// | ||
| - | ====== PyHoca-CLI Installation (LinuxFromScratch) ====== | ||
| <note warning> | <note warning> | ||
| Line 56: | Line 57: | ||
| </ | </ | ||
| - | 7. | + | 7. FIXME -> nxproxy will become part of the nx-libs.git project... |
| Install nxproxy from git | Install nxproxy from git | ||
| < | < | ||
wiki/development/build-howto-linux/pyhoca-cli.1321352483.txt.gz · Last modified: 2013/03/08 13:31 (external edit)
Imprint & Legal Disclaimer -
Data Protection & Privacy Statement
Except where otherwise noted, content on this wiki is licensed under the following license: GNU Free Documentation License 1.3