Differences

This shows you the differences between two versions of the page.

--- doc:howto:x2goclient-file-sharing [2017/01/26 14:43]
stefanbaur [Manually mounting Shared Folders on Demand]
+++ doc:howto:x2goclient-file-sharing [2017/01/26 14:47]
stefanbaur [Running the Session] - added tip w/ link to manual mounting instructions
@@ Line 37: / Line 37: @@
 Make sure you've checked the ''Automount'' checkbox as well as the one that says ''Use SSH port forwarding...''. The latter should be enabled by default.
+<note tip>If you decide against automounting, see [[doc:howto:x2goclient-file-sharing#manually_mounting_shared_folders_on_demand|Manually mounting Shared Folders on Demand]] below for manual mounting instructions.</note>
 === Optionally activate Filename Charset Translation ===
@@ Line 47: / Line 48: @@
 {{:doc:howto:filesharing-7.png|}}
-Once you're connected, you should see a symlink ''media'' in your home directory. Follow that symlink.
+Once you're connected, you should see a symlink ''media'' in your home directory, assuming you followed our suggestion to use the Automount feature. Follow that symlink.
+<note tip>If you decided against automounting, see [[doc:howto:x2goclient-file-sharing#manually_mounting_shared_folders_on_demand|Manually mounting Shared Folders on Demand]] below for manual mounting instructions.</note>
 === Locate your Shared Folders ==

X2Go - everywhere@home