This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision | ||
wiki:obsolete:x2goserver-installation-gentoo [2011/11/15 11:39] sunweaver |
— (current) | ||
---|---|---|---|
Line 1: | Line 1: | ||
- | ====== Build X2GoServer for Gentoo ====== | ||
- | FIXME FIXME FIXME FIXME | ||
- | |||
- | THIS PAGE IS VERY OLD AND VERY PROBABLY NOT UP-TO-DATE!!!!! | ||
- | |||
- | FIXME FIXME FIXME FIXME | ||
- | |||
- | ====== Choose your ebuild source ====== | ||
- | |||
- | Gentoo has x2goserver ebuilds in the main tree, which is the recommended place to start. If you're an experienced gentoo user & feeling adventurous, | ||
- | http:// | ||
- | |||
- | Latest version in main tree 2011-03-15: net-misc/ | ||
- | |||
- | ====== Set your USE flags ====== | ||
- | |||
- | Check your USE flags pertaining to x2goserver | ||
- | |||
- | '' | ||
- | |||
- | The most basic install can be done with USE=" | ||
- | |||
- | If you need to change USE flags, use the normal mechanisms of editing / | ||
- | http:// | ||
- | |||
- | ====== Do the emerge ====== | ||
- | |||
- | Simple enough... | ||
- | |||
- | '' | ||
- | |||
- | Note: as of 2011-03-15 there is a missing dependency on media-fonts/ | ||
- | |||
- | '' | ||
- | ====== Configuration ====== | ||
- | |||
- | Remember to check log messages after the emerge, because there are important configuration details still to be handled (you do have PORTAGE_ELOG_SYSTEM and PORTAGE_ELOG_CLASSES set, right? | ||
- | http:// | ||
- | |||
- | At this time, there are 2 tasks that must be done manually | ||
- | |||
- | * initialize the sqlite database | ||
- | / | ||
- | | ||
- | * configure sudo so that users who should be able to start x2go sesssions can run / | ||
- | For instance, the log message suggests adding following line to / | ||
- | %users ALL=(ALL) NOPASSWD: / |