This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
wiki:development:nxlibs-repository [2012/01/30 12:44] ncryer |
wiki:development:nxlibs-repository [2012/02/28 10:42] ncryer [Create new patch] |
||
---|---|---|---|
Line 141: | Line 141: | ||
dquilt pop -a | dquilt pop -a | ||
</ | </ | ||
- | check your changes with "git status" | + | check your changes with "git status" |
< | < | ||
- | * Update patch: 202_nx-x11_enable-xinerama.full.patch, | + | * Update patch: 202_nx-x11_enable-xinerama.full.patch, |
- | | + | < |
+ | </ | ||
+ | commit your changes with " | ||
+ | ==== Create new patch ==== | ||
+ | apply paches until you reach the code state where you want to begin with your new patch | ||
+ | < | ||
+ | dquilt push | ||
+ | </ | ||
+ | create new patch NUMBER_NXCOMPONENT_DESCRIPTION.full.patch, | ||
+ | < | ||
+ | dquilt new 203_nxagent_disable-rootless-exit.full.patch | ||
+ | </ | ||
+ | add files, which you want to patch with | ||
+ | < | ||
+ | dquilt add DATEINAME | ||
+ | </ | ||
+ | edit files, you want to patch and save the changes | ||
+ | < | ||
+ | dquilt refresh | ||
+ | </ | ||
+ | revoke all patches with | ||
+ | < | ||
+ | dquilt pop -a | ||
+ | </ | ||
+ | check your changes with "git status" | ||
+ | < | ||
+ | * Create patch: 203_nxagent_disable-rootless-exit.full.patch, | ||
+ | < | ||
</ | </ | ||
commit your changes with " | commit your changes with " | ||
- |