This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
wiki:development:build-howto-mswin:x2goclient [2020/02/05 11:15] ionic Add initial instructions for building libssh from source. Currently just unpacking and patching. |
wiki:development:build-howto-mswin:x2goclient [2020/02/06 10:27] ionic Add staging prefix for later installation. |
||
---|---|---|---|
Line 167: | Line 167: | ||
Move the patches to the respective source directory and apply them in order. | Move the patches to the respective source directory and apply them in order. | ||
+ | |||
+ | If needed, install or update '' | ||
+ | |||
+ | == Configuration == | ||
+ | |||
+ | Open a terminal window. Crucially, this must **not** be a '' | ||
+ | |||
+ | Make sure that the mingw toolchain that was used to build Qt (and will be used to build X2Go CLient later on) is part of the %PATH% variable. On the X2Go Windows Builder, a session spawned via '' | ||
+ | |||
+ | Go to the unpacked source directory: < | ||
+ | |||
+ | Create and switch to a build subdirectory: | ||
+ | |||
+ | The pre-built libssh versions in '' | ||
+ | |||
+ | Call '' | ||
+ | |||
+ | == Build == | ||
+ | |||
+ | Build the software like any other, append '' | ||
+ | |||
+ | < | ||
===== Build X2Go Client ===== | ===== Build X2Go Client ===== | ||
Line 628: | Line 650: | ||
- libssh library ([[wiki: | - libssh library ([[wiki: | ||
* '' | * '' | ||
- | - libzip library (available [[http:// | ||
- | * '' | ||
- | - zlib library for libzip (available [[http:// | ||
- | * '' | ||
- zlib library for libssh (available [[http:// | - zlib library for libssh (available [[http:// | ||
* '' | * '' |