This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
wiki:components:printing [2011/11/12 14:38] sunweaver |
wiki:components:printing [2011/11/19 19:39] andy.graybeal |
||
---|---|---|---|
Line 40: | Line 40: | ||
For single-node X2Go printing (means: all steps of the printing process take place on the same machine) only one further step for setting up X2Go printing is necessary: after installing the X2Go CUPS engine (package: '' | For single-node X2Go printing (means: all steps of the printing process take place on the same machine) only one further step for setting up X2Go printing is necessary: after installing the X2Go CUPS engine (package: '' | ||
- | - install | + | - install |
+ | $ sudo aptitude install | ||
+ | </ | ||
- add a new printer in CUPS, possibly named: »x2goprinter« (name is arbitrary) | - add a new printer in CUPS, possibly named: »x2goprinter« (name is arbitrary) | ||
- as printing device (i.e. backend) you should select the “Virtual X2go Printer” | - as printing device (i.e. backend) you should select the “Virtual X2go Printer” | ||
Line 47: | Line 49: | ||
* model: »Generic CUPS-X2GO Printer« | * model: »Generic CUPS-X2GO Printer« | ||
- | You may configure further options by editing the file “/ | + | You may configure further options by editing the CUPS-X2Go config |
< | < | ||
Line 69: | Line 71: | ||
< | < | ||
+ | ==== Client Side ==== | ||
+ | - Run x2goclient | ||
+ | - Click on Settings (the wrench icon) | ||
+ | - Select the Printing Tab | ||
+ | - Select the " | ||