This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
doc:installation:x2goserver [2014/12/17 13:04] sunweaver |
doc:installation:x2goserver [2015/01/04 18:00] mikedep333 Refactor RHEL/EPEL to separate OBS vs packages.x2go.org |
||
---|---|---|---|
Line 145: | Line 145: | ||
sudo yum install x2goserver-xsession | sudo yum install x2goserver-xsession | ||
</ | </ | ||
- | ===== RHEL 5 ===== | + | ===== EPEL 5 (via Opensuse Build Service) |
[[wiki: | [[wiki: | ||
- | |||
==== Installing Required Dependencies (fuse and perl modules) ==== | ==== Installing Required Dependencies (fuse and perl modules) ==== | ||
=== Download required packages manually === | === Download required packages manually === | ||
Line 162: | Line 161: | ||
* '' | * '' | ||
* '' | * '' | ||
- | |||
==== Installing X2Go Server ==== | ==== Installing X2Go Server ==== | ||
You should now be able to install the '' | You should now be able to install the '' | ||
Line 214: | Line 212: | ||
Verbindung fehlgeschlagen DBD:: | Verbindung fehlgeschlagen DBD:: | ||
+ | ===== EPEL 5 (via packages.x2go.org) ===== | ||
+ | |||
+ | <note warning> | ||
+ | |||
+ | [[http:// | ||
+ | ==== Installing Required Dependencies (fuse and perl modules) ==== | ||
+ | === Download required packages manually === | ||
+ | |||
+ | One approach is to download required packages manually. Yum will tell you what is needed, when you ask it to install '' | ||
+ | |||
+ | * perl(DBI:: | ||
+ | * perl(File:: | ||
+ | * perl(Sys:: | ||
+ | * fuse - fuse-2.7.4-8.el5.x86_64.rpm | ||
+ | * libfuse.so.2 - fuse-libs-2.7.4-8.el5.x86_64.rpm | ||
+ | * fuse-sshfs - fuse-sshfs-2.2-1.el5.rf.x86_64.rpm | ||
+ | |||
+ | * '' | ||
+ | * '' | ||
+ | * rpm'' | ||
+ | ==== Installing X2Go Server ==== | ||
+ | You should now be able to install the '' | ||
+ | |||
+ | yum install x2goserver |