This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
doc:howto:x2goclient-file-sharing [2017/01/26 14:03] stefanbaur [Setting up File Sharing in X2GoClient] - added version info |
doc:howto:x2goclient-file-sharing [2017/01/26 14:09] stefanbaur Added Instructions for manual mounting |
||
---|---|---|---|
Line 3: | Line 3: | ||
The following screenshots were made using [[http:// | The following screenshots were made using [[http:// | ||
+ | |||
+ | <note important> | ||
===== Session Setup ===== | ===== Session Setup ===== | ||
Line 57: | Line 59: | ||
You can now navigate to one of the shared folders and access it like it was a local folder. All changes will be replicated instantly. Note that on the Linux side, you will always see file extensions (like '' | You can now navigate to one of the shared folders and access it like it was a local folder. All changes will be replicated instantly. Note that on the Linux side, you will always see file extensions (like '' | ||
+ | |||
+ | ===== Manually mounting Shared Folders on Demand ===== | ||
+ | If you've decided against using the Automount feature, you will need to mount the Shared Folder(s) manually before you can use them. | ||
+ | |||
+ | How you mount them manually depends on what checkboxes you checked under | ||
+ | Options/ | ||
+ | |||
+ | If you set X2GoClient to minimize into the system tray, then you right-click that icon, select the session name, then '' | ||
+ | |||
+ | If, instead, you have the X2GoClient window on your screen even with an active connection, click on the small folder icon, that's the left of the three icons '' | ||
+ | |||
+ | From there, the steps are the same again for both variants. | ||
+ | |||
+ | Click the name of the share in the window that has opened now | ||
+ | |||
+ | Click the '' |