This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
doc:howto:x2gobroker [2017/02/10 17:07] stefanbaur added server descriptions |
doc:howto:x2gobroker [2017/02/13 13:40] stefanbaur [x2goclient1.x2go.example.com] URI fix |
||
---|---|---|---|
Line 44: | Line 44: | ||
* These installations use the Debian preseed mechanism. | * These installations use the Debian preseed mechanism. | ||
* Thus, obviously, you will require a Debian ISO image. | * Thus, obviously, you will require a Debian ISO image. | ||
- | * We used the Debian 8.7.1, i386, netinst image - however, any Debian 8.x image should do. | + | * We used the [[http:// |
* Preseed files can be included into a custom iso image, but for beginners, this may seem rather complicated - That's why we suggest using a web server to store them instead. | * Preseed files can be included into a custom iso image, but for beginners, this may seem rather complicated - That's why we suggest using a web server to store them instead. | ||
* If you don't have Apache/ | * If you don't have Apache/ | ||
Line 54: | Line 54: | ||
* Each system will power down once the installation is complete. **DO NOT** power any one of them up until ALL of them are completely installed and shut down! | * Each system will power down once the installation is complete. **DO NOT** power any one of them up until ALL of them are completely installed and shut down! | ||
* Once installed, power them up in exactly the same sequence - and **WAIT** until bootup is complete before powering up the next! | * Once installed, power them up in exactly the same sequence - and **WAIT** until bootup is complete before powering up the next! | ||
+ | |||
+ | ==== Preseeding - Manual Steps ==== | ||
+ | These are the steps you have to perform manually: | ||
+ | * {{: | ||
+ | * {{: | ||
+ | * You can either choose to confirm this by pressing the ENTER key, or add further options as listed in each preseed file's comment header. | ||
+ | * If you choose not to add further options, a few questions will be asked interactively, | ||
+ | |||
+ | {{: | ||
<note tip>Each entry below contains a hint regarding the minimum requirements for the individual system. If you're using virtual machines, and are low on disk space, feel free to assign sparse files/ | <note tip>Each entry below contains a hint regarding the minimum requirements for the individual system. If you're using virtual machines, and are low on disk space, feel free to assign sparse files/ | ||
<note tip>If you click on the name of a preseed file, like " | <note tip>If you click on the name of a preseed file, like " | ||
- | ==== ldap1.xgo.example.com ==== | + | ==== ldap1.x2go.example.com ==== |
* Minimum RAM required: 256MB | * Minimum RAM required: 256MB | ||
* Minimum disk space required: 4 GB | * Minimum disk space required: 4 GB | ||
Line 224: | Line 233: | ||
echo " | echo " | ||
echo -e " | echo -e " | ||
- | echo "common-auth;*;*;A10000-2400; | + | echo "*;*;*;Al0000-2400; |
echo " | echo " | ||
sed -i -e '/^1/ s/ | sed -i -e '/^1/ s/ | ||
Line 322: | Line 331: | ||
</ | </ | ||
- | ==== nfs1.xgo.example.com ==== | + | ==== nfs1.x2go.example.com ==== |
* Minimum RAM required: 256MB | * Minimum RAM required: 256MB | ||
* Minimum disk space required: 20 GB | * Minimum disk space required: 20 GB | ||
Line 481: | Line 490: | ||
echo " | echo " | ||
echo -e " | echo -e " | ||
- | echo "common-auth;*;*;A10000-2400; | + | echo "*;*;*;Al0000-2400; |
echo " | echo " | ||
sed -i -e '/^1/ s/ | sed -i -e '/^1/ s/ | ||
Line 540: | Line 549: | ||
</ | </ | ||
- | ==== pg1.xgo.example.com ==== | + | ==== pg1.x2go.example.com ==== |
* Minimum RAM required: 256MB | * Minimum RAM required: 256MB | ||
* Minimum disk space required: 20 GB | * Minimum disk space required: 20 GB | ||
Line 697: | Line 706: | ||
echo " | echo " | ||
echo -e " | echo -e " | ||
- | echo "common-auth;*;*;A10000-2400; | + | echo "*;*;*;Al0000-2400; |
echo " | echo " | ||
sed -i -e '/^1/ s/ | sed -i -e '/^1/ s/ | ||
Line 765: | Line 774: | ||
</ | </ | ||
- | ==== x2gobroker1.xgo.example.com ==== | + | ==== x2gobroker1.x2go.example.com ==== |
* Minimum RAM required: 256MB | * Minimum RAM required: 256MB | ||
* Minimum disk space required: 4 GB | * Minimum disk space required: 4 GB | ||
Line 888: | Line 897: | ||
# sources.list line will be left commented out | # sources.list line will be left commented out | ||
- | # CHANGE THIS - you need to download | + | # When this key doesn' |
- | # run these gpg commands to download it: | + | #d-i apt-setup/ |
- | # gpg --keyserver keys.gnupg.net --recv-keys E1F958385BFE2B6E | + | d-i apt-setup/ |
- | # gpg -a --export E1F958385BFE2B6E > x2go.key.gpg | + | |
- | d-i apt-setup/ | + | |
# Task and Package Selection | # Task and Package Selection | ||
Line 918: | Line 925: | ||
x2gobroker-authservice \ | x2gobroker-authservice \ | ||
x2gobroker-daemon \ | x2gobroker-daemon \ | ||
+ | x2gobroker-loadchecker \ | ||
x2gobroker-ssh | x2gobroker-ssh | ||
Line 946: | Line 954: | ||
echo " | echo " | ||
echo -e " | echo -e " | ||
- | echo "common-auth;*;*;A10000-2400; | + | echo "*;*;*;Al0000-2400; |
echo " | echo " | ||
sed -i -e '/^1/ s/ | sed -i -e '/^1/ s/ | ||
Line 1053: | Line 1061: | ||
</ | </ | ||
- | ==== x2goserver1.xgo.example.com ==== | + | ==== x2goserver1.x2go.example.com ==== |
* Minimum RAM required: 256MB | * Minimum RAM required: 256MB | ||
* Minimum disk space required: 8 GB | * Minimum disk space required: 8 GB | ||
Line 1176: | Line 1184: | ||
# sources.list line will be left commented out | # sources.list line will be left commented out | ||
- | # CHANGE THIS - you need to download | + | # When this key doesn' |
- | # run these gpg commands to download it: | + | #d-i apt-setup/ |
- | # gpg --keyserver keys.gnupg.net --recv-keys E1F958385BFE2B6E | + | d-i apt-setup/ |
- | # gpg -a --export E1F958385BFE2B6E > x2go.key.gpg | + | |
- | d-i apt-setup/ | + | |
# Task and Package Selection | # Task and Package Selection | ||
Line 1239: | Line 1245: | ||
echo " | echo " | ||
echo -e " | echo -e " | ||
- | echo "common-auth;*;*;A10000-2400; | + | echo "*;*;*;Al0000-2400; |
echo " | echo " | ||
sed -i -e '/^1/ s/ | sed -i -e '/^1/ s/ | ||
Line 1338: | Line 1344: | ||
</ | </ | ||
- | ==== x2goserver2.xgo.example.com ==== | + | ==== x2goserver2.x2go.example.com ==== |
* Minimum RAM required: 256MB | * Minimum RAM required: 256MB | ||
* Minimum disk space required: 8 GB | * Minimum disk space required: 8 GB | ||
Line 1461: | Line 1467: | ||
# sources.list line will be left commented out | # sources.list line will be left commented out | ||
- | # CHANGE THIS - you need to download | + | # When this key doesn' |
- | # run these gpg commands to download it: | + | #d-i apt-setup/ |
- | # gpg --keyserver keys.gnupg.net --recv-keys E1F958385BFE2B6E | + | d-i apt-setup/ |
- | # gpg -a --export E1F958385BFE2B6E > x2go.key.gpg | + | |
- | d-i apt-setup/ | + | |
# Task and Package Selection | # Task and Package Selection | ||
Line 1524: | Line 1528: | ||
echo " | echo " | ||
echo -e " | echo -e " | ||
- | echo "common-auth;*;*;A10000-2400; | + | echo "*;*;*;Al0000-2400; |
echo " | echo " | ||
sed -i -e '/^1/ s/ | sed -i -e '/^1/ s/ | ||
Line 1592: | Line 1596: | ||
</ | </ | ||
- | ==== x2goclient1.xgo.example.com ==== | + | ==== x2goclient1.x2go.example.com ==== |
* Minimum RAM required: 256MB | * Minimum RAM required: 256MB | ||
* Minimum disk space required: 4 GB | * Minimum disk space required: 4 GB | ||
Line 1715: | Line 1719: | ||
# sources.list line will be left commented out | # sources.list line will be left commented out | ||
- | # CHANGE THIS - you need to download | + | # When this key doesn' |
- | # run these gpg commands to download it: | + | |
- | # gpg --keyserver keys.gnupg.net --recv-keys E1F958385BFE2B6E | + | |
- | # gpg -a --export E1F958385BFE2B6E > x2go.key.gpg | + | |
- | #d-i apt-setup/ | + | |
#d-i apt-setup/ | #d-i apt-setup/ | ||
d-i apt-setup/ | d-i apt-setup/ | ||
Line 1789: | Line 1789: | ||
echo ' | echo ' | ||
echo ' | echo ' | ||
- | echo ' | + | echo ' |
echo ' | echo ' | ||
echo ' | echo ' |