This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
wiki:development:build-howto-linux:x2goserver [2011/11/15 11:06] sunweaver |
wiki:development:build-howto-linux:x2goserver [2011/11/15 11:14] sunweaver |
||
---|---|---|---|
Line 22: | Line 22: | ||
Note: X2GoServer is not dependent on perl-suid anymore (as Perl SUID has been removed from Perl > | Note: X2GoServer is not dependent on perl-suid anymore (as Perl SUID has been removed from Perl > | ||
- | Installation: | + | Installation: |
- | Deinstallation: | + | Deinstallation: |
===== Build Recipes ===== | ===== Build Recipes ===== | ||
Line 121: | Line 121: | ||
</ | </ | ||
- | **8. FIXME -> has to built from nx-libs.git | + | **8. |
+ | Install NoMachine' | ||
- | Install nxcomp from git** | + | **9. |
- | + | ||
- | < | + | |
- | $ git clone git:// | + | |
- | $ cd nxcomp | + | |
- | $ autoconf | + | |
- | $ ./configure --prefix=/ | + | |
- | $ make | + | |
- | $ su -c "make install && / | + | |
- | </ | + | |
- | + | ||
- | **9. FIXME -> has to built from nx-libs.git | + | |
- | + | ||
- | Install nxcompext from git** | + | |
- | + | ||
- | < | + | |
- | $ git clone git:// | + | |
- | $ cd nxcompext | + | |
- | $ autoconf | + | |
- | $ ./configure --prefix=/ | + | |
- | $ make | + | |
- | $ su -c "make install && / | + | |
- | </ | + | |
- | + | ||
- | **10. FIXME -> has to built from nx-libs.git | + | |
- | + | ||
- | Install nxcompshad from git** | + | |
- | + | ||
- | < | + | |
- | $ git clone git:// | + | |
- | $ cd nxcompshad | + | |
- | $ autoconf | + | |
- | $ ./configure --prefix=/ | + | |
- | $ make | + | |
- | $ su -c "make install && / | + | |
- | </ | + | |
- | + | ||
- | **11. | + | |
Install x2goagent from git** | Install x2goagent from git** | ||