This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
wiki:development:build-howto-linux:x2goserver [2011/11/15 10:59] sunweaver |
wiki:development:build-howto-linux:x2goserver [2011/11/15 11:14] sunweaver |
||
---|---|---|---|
Line 2: | Line 2: | ||
//... esp. applies to installation on the Linux-From-Scratch distribution.// | //... esp. applies to installation on the Linux-From-Scratch distribution.// | ||
+ | |||
+ | ===== General Information ===== | ||
+ | |||
+ | Make sure you have read these wiki pages / installed recommended software / development libraries: | ||
+ | |||
+ | * non-X2Go runtime dependencies: | ||
+ | * lsof | ||
+ | * openssh-client | ||
+ | * openssh-server | ||
+ | * libconfig-simple-perl | ||
+ | * makepasswd | ||
+ | * libdbd-pg-perl | ||
+ | * libdbd-sqlite3-perl | ||
+ | * xauth | ||
+ | * X2Go runtime dependencies: | ||
+ | * x2goagent | ||
+ | * NX libraries | ||
+ | |||
+ | Note: X2GoServer is not dependent on perl-suid anymore (as Perl SUID has been removed from Perl > | ||
+ | |||
+ | Installation: | ||
+ | |||
+ | Deinstallation: | ||
+ | |||
+ | ===== Build Recipes ===== | ||
**Run the following commands as a regular, non-root user. You'll need the root password to install them.** | **Run the following commands as a regular, non-root user. You'll need the root password to install them.** | ||
Line 96: | Line 121: | ||
</ | </ | ||
- | **8. FIXME -> has to built from nx-libs.git | + | **8. |
- | + | Install | |
- | Install | + | |
- | + | ||
- | < | + | |
- | $ git clone git:// | + | |
- | $ cd nxcomp | + | |
- | $ autoconf | + | |
- | $ ./ | + | |
- | $ make | + | |
- | $ su -c "make install && / | + | |
- | </ | + | |
- | + | ||
- | **9. FIXME -> has to built from nx-libs.git | + | |
- | + | ||
- | Install nxcompext from git** | + | |
- | + | ||
- | < | + | |
- | $ git clone git:// | + | |
- | $ cd nxcompext | + | |
- | $ autoconf | + | |
- | $ ./configure --prefix=/ | + | |
- | $ make | + | |
- | $ su -c "make install && / | + | |
- | </ | + | |
- | + | ||
- | **10. FIXME -> has to built from nx-libs.git | + | |
- | + | ||
- | Install nxcompshad from git** | + | |
- | + | ||
- | < | + | |
- | $ git clone git:// | + | |
- | $ cd nxcompshad | + | |
- | $ autoconf | + | |
- | $ ./configure --prefix=/ | + | |
- | $ make | + | |
- | $ su -c "make install && / | + | |
- | </ | + | |
- | **11. | + | **9. |
Install x2goagent from git** | Install x2goagent from git** | ||