This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision | ||
wiki:development:build-howto-linux:x2goclient [2013/03/08 13:31] 127.0.0.1 external edit |
wiki:development:build-howto-linux:x2goclient [2020/05/28 22:52] (current) danger89 |
||
---|---|---|---|
Line 1: | Line 1: | ||
- | ====== Build X2GoClient | + | ====== Build X2GoClient ====== |
- | //... esp. applies to installation on the Linux-From-Scratch distribution./ | + | Install |
- | * recommended on the client: pulseaudio | + | < |
- | | + | sudo apt-get install |
- | * libc6 | + | qt4-dev-tools libqt4-dev libqt4-network git \ |
- | | + | libqt4-svg libqtcore4 libqtgui4 \ |
- | | + | |
- | * libldap-2.4-2 | + | |
- | * libqt4-network | + | </ |
- | * libqt4-svg | + | |
- | * libqtcore4 | + | //Note:// Try to use at least libssh >= v0.4.7. |
- | * libqtgui4 | + | |
- | | + | //Note #2:// Recommended package on the client-side: pulseaudio |
- | * libstdc++6 | + | |
- | * libx11-6 | + | |
- | < | ||
**Run the following commands as a regular, non-root user. You'll need the root password to install them.** | **Run the following commands as a regular, non-root user. You'll need the root password to install them.** | ||
- | **1. FIXME -> nxproxy | + | ==== 1. Install nxproxy ==== |
- | Install nxproxy from git** | + | |
+ | You can either install it directly via the package manager, like when using APT: | ||
+ | |||
+ | <code>apt install | ||
+ | |||
+ | **OR** | ||
+ | |||
+ | Install nxproxy from source: | ||
< | < | ||
- | $ git clone git:// | + | $ mkdir ~/x2go && cd ~/x2go |
- | $ cd nxproxy | + | $ git clone git:// |
+ | $ cd nx-libs/nxproxy | ||
$ autoconf | $ autoconf | ||
$ ./configure --prefix=/ | $ ./configure --prefix=/ | ||
- | $ make | + | $ make -j 4 |
- | $ su -c "make install" | + | $ sudo make install |
</ | </ | ||
- | **2a. | + | ==== 2. Install x2goclient from git ==== |
- | Install x2goclient from git** | + | |
< | < | ||
Line 41: | Line 45: | ||
$ cd x2goclient | $ cd x2goclient | ||
$ export PREFIX=/usr | $ export PREFIX=/usr | ||
- | $ sudo su -c "make build_client && | + | $ make -j 4 |
+ | $ sudo make install_client | ||
</ | </ | ||
- | **2b. | ||
- | Also build+install x2goplugin** | ||
- | < | ||
- | $ sudo su -c "make build_plugin && make install_plugin" | ||
- | </ | ||