Build PyHoca-CLI for GNU/Linux

… esp. applies to installation on the Linux-From-Scratch distribution.

WORK IN PROGRESS – NOT FINISHED YET

1. Install argparse

$ wget http://argparse.googlecode.com/files/argparse-1.2.1.tar.gz
$ tar xf argparse-1.2.1.tar.gz
$ cd argparse-1.2.1
$ su -c "python setup.py install"

2. Install setproctitle

$ wget http://pypi.python.org/packages/source/s/setproctitle/setproctitle-1.1.2.tar.gz
$ tar xf setproctitle-1.1.2.tar.gz
$ cd setproctitle-1.1.2
$ su -c "python setup.py install"

3. Install gevent

$ wget http://pypi.python.org/packages/source/g/gevent/gevent-0.13.6.tar.gz
$ tar xf gevent-0.13.6.tar.gz
$ cd gevent-0.13.6
$ su -c "python setup.py install"

4. Install paramiko

$ wget http://www.lag.net/paramiko/download/paramiko-1.7.7.1.tar.gz
$ tar xf paramiko-1.7.7.1.tar.gz
$ cd paramiko-1.7.7.1
$ su -c "python setup.py install"

5. Install python-x2go

$ git clone git://code.x2go.org/python-x2go
$ cd python-x2go
$ su -c "python setup.py install"

6. Install pyhoca-cli

$ git clone git://code.x2go.org/pyhoca-cli
$ cd pyhoca-cli
$ su -c "python setup.py install"

7. FIXME → nxproxy will become part of the nx-libs.git project…

Install nxproxy from git

$ git clone git://code.x2go.org/nxproxy
$ cd nxproxy
$ autoconf 
$ ./configure --prefix=/usr
$ make
$ su -c "make install"